Especially suitable for cast iron mold, since the nickel-containing reduced, it is possible to reduce the cost, hard surface cast mold making backing buffer layer.

CMC-E12HA HRC 57-592.4, 3.2, 4.0

Excellent red stripe, widely used in forging, Die, anti-abrasion hard surface production, high hardness stability, for use in forging die, stamping die, die casting, die-cut edging, Cars, hot rolled round, hard surface wear of parts production.

CMC-E60AHRC 60 ~ 622.6, 3.2

Stability of high hardness, wear resistance, high temperature. Suitable for medium carbon steel, low alloy steel hard surface of production, mechanical wear of the cutting tool repair, Cars, forging die forging welding incision.

CMC-E30N high tension, high toughness 2.6, 3.2

Engaging high hardness steel, steel seat fixed, hard surface cast mold making backing buffer layer, cracking of the welding.

CMC-E61N3.2 * 350mm

Adapted, or welded water casting of cast iron, alloy cast iron, steel and cast iron engaged, nickel and alloys.

CMC-E7WHRC 53 ~ 55 3.2, 4.0

Suitable for air-cooled steel (ICD5) or blade of steel production and welding damage, in particular for the production of automotive sheet metal die cutting edge, piercing and flanging parts, light sheet metal stamping die cutting angle, side. For the production of cutting tools, the same may be surfacing as a cutting edge. Hard surface can also be applied to the production of wear parts.

CMC-E47NHRC 44 ~ 50 3.2 * 350mm

Can be directly on the cast iron welding rod, cast iron blade used in the molding, calendering site is very convenient.

CMC-EH10 HRC 46 ~ 52 3.2, 4.0

Suitable for medium and large forging die of production, repair and resurfacing. Because of the reduced chromium content, and improve the alloy composition of molybdenum, tungsten, vanadium, forming a good balance of toughness and wear high temperature, a substantial increase in cross-sectional area larger hot die life. Widely used in the large hot forging die, forging die, hot gravity die casting, hard surface wear of parts production.

CMC-EH13 HRC 55 ~ 58 2.4, 3.2

Suitable for hot-working tool damage resistance welding, especially eager to tools, hot cutting tools, hot corner cutting edge of planing tools. For the production of shearing tools, the same can by welding on low alloy steel or general as a cutting edge.